Electrical Engineering Project Topic: Electrical engineering project topics and research materials are born out of the research ideas that come into bear during students’ practical seasons in school. Weather achieved through collective effort or individual effort, final year projects in electrical engineering are most of the time exhibited or constructed, just as the case may be. Electrical engineering project topics are driven to solve technical problems especially such that surround electrical hardware and software. Project topics of this course of study should yield to the research procedures stipulated by institutions. Moreso, project topics of electrical engineering should be subject to scrutiny by the project supervisor to ensure that the right research procedure for presenting undergraduate research is followed with caution.
Filters: Undergraduate (HND,BSc,BTech) Masters (MSc,MTech) PhD Thesis
LIST OF ELECTRICAL ENGINEERING PROJECT TOPICS AND MATERIALS | ||
---|---|---|
S/N | Project Topic | |
1 |
DESIGN AND FABRICATION OF MAIZE CORN-ON-COB TRAY DRYERABSTRACT This study was carried out to generate a design data, design and fabricate a maize corn on cob tray dryer used by maize farmers. Ripped maize corns with husks were bought from the market and preserved to retained its moisture content, dehusked and thereafter, dried to a given percentage moisture content of 15%. This was done by laboratory dryer. The drying rate data was generated and the ... Continue Reading »
Item Type & Format: Project Material - Ms Word |
50 pages |
| |
2 |
AN INSIGHT ON THE DESIGN AND CONSTRUCTION OF A POWER LINE VANDALISM MONITORING SYSTEM USING ELECTRONIC SYSTEMCHAPTER ONE INTRODUCTION 1.1 BACKGROUND OF THE STUDY This project gives the insight on the design and construction of a transmission power line vandalism detector system. Vandalism means destructive action. It is a hateful and deliberate defacement/destruction of somebody else’s property or national assets like the high voltage transmission power lines, transmission towers and distribution trans... Continue Reading »
Item Type & Format: Project Material - Ms Word |
42 pages |
| |
3 |
STRATEGIES FOR IMPROVING THE USE OF ELECTRONIC MEDIA IN TEACHING ELECTRICAL AND ELECTRONICS SUBJECTS IN TECHNICAL COLLEGES.TABLE OF CONTENTS Title page i Approval page ii Declaration iii Dedication iv Acknowledgment v Table of contents vi List of figure/tables viii Abstract ix CHAPTER ONE: INTRODUCTION Background of the Study 1 Statement of the Problem 6 Purpose of the Study 8 Significance of the Study 9 Research questions 10 Delimitation 10 CHAPTER TWO: REVIEW OF THE RELATED LITERATURE An overview of electronic media... Continue Reading »
Item Type & Format: Project Material - Ms Word |
52 pages |
| |
4 |
DESIGN AND CONSTRUCTION OF A SINGLE PHASE AUTO-TRANSFORMER OF RATING IKVA, 240V/110, 80 12V, 6VABSTRACT This project work up deals on the design and construction of a single phase step down nations fermor, with raking IKVA, 240V/11OV, 80V 12U, 6V. It is a multi circuit transformer that has one input as the primary and tappins to produce the output (secondary). It is considered as a single coil in series with the supply and a common coil to the head. It is experimentally done using flat meta... Continue Reading »
Item Type & Format: Project Material - Ms Word |
50 pages |
| |
5 |
THE EFFECT OF TEACHER-STUDENTS RELATIONSHIP ON STUDENTS ACADEMICS PERFORMANCE IN SOME SELECTED TECHNICAL COLLEGES IN NIGER AND KADUNA STATETABLE OF CONTENTS Title page i Approval page ii Declaration iii Dedication iv Acknowledgement v Table of contents vi Abstract viii CHAPTER ONE : INTRODUCTION Background of the study 1 Statement of the problem 5 Purposes of the study 5 Research question 7 Significance of the study 7 Delimitation of the study 8 Operational definition of terms 8 CHAPTER TWO: REVIEW OF RELATED LITERATURE Introduction ... Continue Reading »
Item Type & Format: Project Material - Ms Word |
52 pages |
| |
6 |
DESIGN AND CONSTRUCTION OF AN AUDIO AMPLIFIERCHAPTER ONE INTRODUCTION PREAMBLE These days’ people normally have to address large gathering at a time and an efficient means of communication has to be used, if not, the massage would not be understood. This fact led us into this project which was explained fully in due course. The project is DEFINITION OF TERMS AMPLIDIER The basic principle in the operation of an audio amplifier involves ... Continue Reading »
Item Type & Format: Project Material - Ms Word |
30 pages |
| |
7 |
DESIGN AND CONSTRUCTION OF DENSITY BASED TRAFFIC LIGHT CONTROL SYSTEMABSTRACT Traffic congestion is a severe problem in many major cities across the world and it has become and nightmare for the commuters in these cities. The conventional traffic light system is based on fixed time concept allotted to each side of the junction which cannot be varied as per varying traffic density thereby causing more time wasted. It is in this view that density base traffic light c... Continue Reading »
Item Type & Format: Project Material - Ms Word |
69 pages |
| |
8 |
THE DESIGN AND CONSTRUCTION OF FM RADIO TRANSMITTERABSTRACT An FM transmitter is an electronic device which, with the aid of an antenna, produces radio waves. The transmitter itself generates a radio frequency alternating current, which is applied to the antenna. When excited by this alternating current, the antenna radiates radio waves. Frequency modulation (FM) transmitter generates the radio waves by varying the radio signal's frequency slightl... Continue Reading »
Item Type & Format: Project Material - Ms Word |
43 pages |
| |
9 |
SOLAR POWER GENERATION FOR INDIVIDUAL IN RURAL AREA CAN SOLVE THE PROBLEMS OF POWER IN THIS COUNTRY (NIGERIA).CHAPTER ONE 1.0 INTRODUCTION 1.1 BACKGROUND OF STUDY Energy is a basic need for the development of socio economic and enhancement of people’s living standard. As the people becomes more developed then the energy consumption also increases but the conventional energy have a negative impact in our environment and it is also in the way of exhaustion. [Lesourd, 2001; Changa et al 2003] Getting an ac... Continue Reading »
Item Type & Format: Project Material - Ms Word |
54 pages |
| |
10 |
CONSTRUCTION OF MICROCONTROLLER BASED VEHICLE SPEED ALARM.ABSTRACT The project is based on Construction of microcontroller vehicle speed alarm system which automatically warns the driver by activating a panic alarm which is triggered on when the driver exceeds the speed limit set in the system which also stops the alarm when the speed is reduced below the set speed limit. A speedometer system is used to monitor the speed of the car. The voltage output of... Continue Reading »
Item Type & Format: Project Material - Ms Word |
52 pages |
| |
11 |
INSTALLATION OF A SOLAR INVERTER AND A DEEP CYCLE RECHARGEABLE BATTERIES FOR POWERING (30) THIRTY DESKTOP COMPUTERS AND A PROJECTOR IN THE COMPUTER RO...CHAPTER ONE 1.0 INTRODUCTION 1.1 BACKGROUND OF THE STUDY Electricity is a form of energy that comes in positive and negative forms, that occur naturally (as lighting), or is produced (as in generator). It is a form of energy, which we use to power machines and electrical devices. When the charges are not moving, electricity is called static electricity. When the charges are not moving they are an ... Continue Reading »
Item Type & Format: Project Material - Ms Word |
52 pages |
| |
12 |
DESIGN AND IMPLEMETATION OF ARDUINO BASED DIGITAL CLOCK WITH ALARMABSTRACT Nowadays, owing to the very busy schedules of many, a lot of people get carried away and consequently loose count of time. Hence, there is need to devise a system that reminds people of the time. The objective of this project is to design and construct an Arduino digital clock that can display time in discrete format, keep track of time and also tell the time verbally at an hourly basis. ... Continue Reading »
Item Type & Format: Project Material - Ms Word |
46 pages |
| |
13 |
CONSTRUCTION OF CAR TOUCH INTRUDER ALARMCHAPTER ONE: INTRODUCTION 1.1. Background of the Study The first car alarm was a primitive contraption that utilized a bell or horn connected to the drive shaft. It was created by an unnamed Nebraska inventor in June 20th, 1920. It utilizes the drive shaft to operate its own bell or horn signal when the car is properly moved. This is just a little talk on a car alarm but not a car touch intruder a... Continue Reading »
Item Type & Format: Project Material - Ms Word |
76 pages |
| |
14 |
CONSTRUCTION OF UNTERRUPTIBLE POWER SUPPLYABSTRACTUninterruptible power supplies (UPS) are used to provide power when regular utility power is unavailable. Although they are commonly used for providing power in remote locations or emergencies, this is not because they are the same as auxiliary power units, emergency power units or standby generators.Unlike the aforementioned power sources, UPS provides an immediate and continuous supply o... Continue Reading »
Item Type & Format: Project Material - Ms Word |
52 pages |
| |
15 |
PC-BASED MULTIPOINT TEMPERATURE MONITORING AND CONTROL SYSTEM USING CUTIX PLC, NNEWI AS CASE STUDYABSTRACT A temperature monitoring system which can be used to monitor the temperature of industrial processes has been designed and implemented in the course of this project. This system relied upon a controller which is connected to temperature sensors. The controller compares the actual temperature to the desired control temperature, or set point, and provides an output to a control element. Mos... Continue Reading »
Item Type & Format: Project Material - Ms Word |
127 pages |
| |
16 |
AN IMPROVED FAULT LOCATION ON POWER SYSTEM TRANSIMMISION LINES USING FUZZY LOGIC APPROACHCHAPTER ONE INTRODUCTION 1.1. BACKGROUND The reliable operation of large power systems with small stability margin is highly dependent on systems and protection devices. The application of microprocessor based (numeric) relaying protection has improved performance over time but, this has not led to a major impact on speed, sensitivity, and selectivity of primary protective relays. However decision... Continue Reading »
Item Type & Format: Project Material - Ms Word |
92 pages |
| |
17 |
MICROCONTROLLER BASED DOT MATRIX ADVERT DISPLAY SYSTEMCHAPTER ONE INTRODUCTION The purpose of this project is to produce a narrative description of the design and construction of a microcontroller based dot matrix advert display. Firstly computer aided design is the modeling of physical system on Computers allowing both interactive and automatic analysis of design variant and the expression of design in a form suitable for manufacturing. This follows... Continue Reading »
Item Type & Format: Project Material - Ms Word |
64 pages |
| |
18 |
DESIGN AND CONSTRUCTION OF A 1KVA MOBILE SOLAR GENERATORCHAPTER ONE INTRODUCTION 1.1 Background of study A power inverter, or inverter, is an electronic device or circuitry that changes direct current (DC) to alternating current (AC). (The Authoritative, 2000). The input voltage, output voltage and frequency, and overall power handling depend on the design of the specific device or circuitry. The inverter does not produce any power; the power is provid... Continue Reading »
Item Type & Format: Project Material - Ms Word |
73 pages |
| |
19 |
DESIGN OF AN EQUIPMENT THAT CAN FACILITATE A CONVENIENT AND EASY WAY OF CONTROLLING OUR DOMESTIC APPLIANCESCHAPTER ONE INTRODUCTION 1.1 OBJECTIVE OF PROJECT The need for a remote control alert system that can control domestic appliances and various lighting points and sockets has often been a concern for users. At times users find it inconvenient and time consuming to go around turning their appliances on or off each time there is power outage or each time they are leaving the house for work. It has al... Continue Reading »
Item Type & Format: Project Material - Ms Word |
84 pages |
| |
20 |
CONSTRUCTION AND DESIGN OF POLICE SIRENDEDICATIONWe dedicate this project work to Almighty God, the source of all knowledge, wisdom and understanding, for being there for us throughout the period of our study and to our lovely parents, Mr. and Mrs. Abido, and Sir & Lady Christopher Korugbo for their parental care, who has always been our inspiration.TABLE OF CONTENTTITLE PAGE=====================================iDEDICATION=========... Continue Reading »
Item Type & Format: Project Material - Ms Word |
52 pages |
|
Download Electrical Engineering Final Year Research Project Topics - Free Project Topics | Codemint and Research Materials. Get Complete Chapter 1-5 Project Materials and Research Topics for HND, BSc, MSc in Doc & PDF. Final Year Projects and Research Materials on CodeMint