 The Complete Research Material is averagely 90 pages long and it is in Ms Word Format, it has 15 Chapters.
 Major Attributes are Abstract, All Chapters, Figures, Appendix, References.
 Study Level: BTech, BSc, BEng, BA, HND, ND or NCE.
 Full Access Fee: ₦5,000
Get the complete project »
CHAPTER ONE
GENERAL INTRODUCTION
1.1 BACKGROUND TO THE STUDY
Energy is a basic necessity for the economic development of a nation. There are different forms of energy, but the most important form is the electrical energy, (Gupta, 2008) A modern and civilized society is so much dependent on the use of electrical energy. Activities relating to the generation, transmission and distribution of electrical energy have to be given the highest priority in the national planning process of any nation because of the importance of electrical energy to the economic and social development of the society. In fact, the greater the per capital consumption of electrical energy in a country, the higher the standard of living of its people. Therefore, the advancement of a country is measured in terms of its per capital consumption of electrical energy, (Gupta, 2008).
Power plants’ planning in a way to meet the power network load demand is one of the most important and essential issues in power systems. Since transmission lines connect generating plants and substations in power network, the analysis, computation and reduction of transmission losses in these power networks are of great concern to scientists and engineers.
A lot of research works have been carried out on the above listed aspects. (Zakariya, 2010) made a comparison between the corona power loss associated with HVDC transmission lines and the ohmic power loss. The corona power loss and ohmic power loss were measured and computed for different transmission line configurations and under fair weather and rainy conditions. It was pointed out in the work that the general trend of neglecting the corona power loss is not always valid. It was found from the comparison that, when the transmission line is moderately or lightly loaded, the percentage of corona power loss to ohmic power loss could reach up to one hundred percent especially if the transmission line is operating at a voltage well above the corona onset value. This percentage is also found to increase substantially under rainy conditions. Finally, it was also discovered that, the ratio of corona to ohmic power loss, decreases with increasing number of bundles. (Numphetch et al., 2011) worked on loss minimization using optimal power flow based on swarm intelligences.
(Thabendra et al., 2009) considered multiobjective optimization methods for power loss minimization and voltage stability while (Abdullah et al., 2010) looked at transmission loss minimization and power installation cost using evolutionary computation for improvement of voltage stability. (Bagriyanik et al., 2003) used a fuzzy multiobjective optimization and genetic algorithmbased method to find optimum power system operating conditions. In addition to active power losses, series reactive power losses of transmission system were also considered as one of the multiple objectives. (Onohaebi, 2010) considered the relationship between distance and loadings on power losses using the existing 330 KV Nigerian transmission network as a case study in his empirical modelling of power losses as a function of line loadings and lengths in the Nigeria 330 KV transmission lines while (Moghadam, 2010) developed a new method for calculating transmission power losses based on exact modelling of ohmic loss. (Ramesh et al., 2009) looked at minimization of power loss in distribution networks by using feeder restructuring, implementation of distributed generation and capacitor placement method. (Lo, 2006) considered feeder reconfiguration for losses reduction in distribution systems. Others who researched into power losses include (Rugthaicharoencheep, 2009),
(Crombie, 2006), to mention a few, various researchers have also worked on the flow of power on electrical networks. (Pandya, 2008) presents a comprehensive survey of various optimization methods for solving optimal power flow problems. The methods considered in the work include linear programming, NewtonRaphson, quadratic programming, nonlinear programming, interior point and artificial intelligence. Under the artificial intelligence method, the following were also considered artificial neural network method, fuzzy logic method, genetic algorithm method, evolutionary programming method, ant colony optimization method and particle swarm optimization method. It was found in the paper that the classical methods have a lot of limitations. In most cases, mathematical formulations have to be simplified to get the solutions because of the extremely limited capability to solve realworld largescale power system problems. The classical methods are weak in handling qualitative constraints and they have very poor convergence. The methods are also very slow and computationally expensive in handling largescale optimal power flow problems. It was also discovered in the paper that the artificial intelligence methods are relatively versatile for handling various qualitative constraints and that the methods can find multiple optimal solutions in a single simulation.
They are therefore suitable in solving multiobjective optimization problems. (William, 2002) looked at alternative optimal power flow formulations while (Claudio et al., 2001) worked on comparison of voltage security constraint using optimal power flow techniques.
(Roya et al., 2008) considered power flow modelling for power systems with dynamic flow controller. Other researchers who also worked on power flow include (Bouktir et al., 2004).
In addition, several researchers have also worked on electric power systems. (Aderinto, 2011) worked on an optimal control model of the electric power generating system. In the research work, she developed a mathematical model for the electric power generating system using the optimal control approach and characterized the mathematical model by prescribing the conditions for the optimality of the electric power generating system and the analytic requirements for the existence and uniqueness of the solution to the system. The optimality condition for the model was determined and the model was solved analytically and numerically. In the study, two control variables were identified, the first for load shedding among the generators in the system and the second for restriction on the capacity of the generators. The problem was formulated based on the second control variable since the first control variable can only be on or off as the case may be. The optimality conditions for the system were imposed implicitly on the controls and the mathematical model represents a stable lossfree generating system. From the work, it was shown that the generation loss can be controlled and stabilized. (Oke et al., 2007) considered the perspectives on electricity supply and demand in Nigeria while (Ibe, 2007) looked at optimized electricity generation in Nigeria. (Bamigbola, 2009) characterized an optimal control model of electric power generating system. (Karamitsos, 2006) considered an analysis of blackout for electric power transmission systems while (Aderinto et al., 2010) looked at optimal control of air pollution with application to power generating system model. Others whose researches touched on electric power systems include (Savenkov, 2008) to list a few. As such, much emphasis has been on proper design of electrical power systems and reduction of losses using feeder reconfiguration and evolutionary techniques.
Loss minimization is a critical component for efficient electric power supply systems.
Losses in an electric power system should be around 3 percent to 6 percent, (Ramesh et al., 2009). In developed countries, it is not greater than 10 percent. However, in developing countries it is still over 20 percent, (Ramesh et al., 2009). Therefore stakeholders in the power sector are currently interested in reducing the losses on electric power lines to a desired and economic level. The purpose of this research work, therefore, is to develop mathematical models for power losses along transmission lines and to minimize the losses using classical optimization techniques.
1.2 OBJECTIVES OF THE STUDY
Power losses result in lower power availability to the consumers, leading to inadequate power to operate their appliances. High efficiency of power system is determined by its low power losses. The goal of this research work therefore is to use classical optimization techniques to minimize the transmission power losses on transmission lines. The objectives of the research work are to:
(i.) Develop mathematical models for electric power flow and power losses along electric power transmission lines;
(ii.) Solve the mathematical models for electric power flow along transmission lines analytically;
(iii.) Develop empirical models of power losses as functions of distance;
(iv.) Minimize power losses using the classical optimization technique.
1.3 SIGNIFICANCE OF THE STUDY
The mathematical representation of power flow along transmission lines provides a better understanding of the flow of electric power on transmission lines and the evolution of voltage and current along the lines. The mathematical representation of power losses along transmission lines gives an insight into the major problems on electric power transmission.
The minimization of losses on electric power transmission lines using classical optimization technique provides a solution, in a compact form, to the major problem encontered in power transmission.
1.4 ORGANIZATION OF THE THESIS
This dissertation report is divided into five chapters. The first chapter is an introduction of the work done. The second chapter is the literature and background review of the work. Chapter three handles methodology, design and implementation of the work done while chapter four is the data presentation and analysis of the work. Chapter five is the conclusion and recommendation of the work for future research and study in this area.
You either get what you want or your money back. T&C Apply
You can find more project topics easily, just search

SIMILAR MATHEMATICS FINAL YEAR PROJECT RESEARCH TOPICS

1. EVALUATION OF RELIABILITY AND AVAILABILITY CHARACTERISTICS OF TWO DIFFERENT SYSTEMS USING LINEAR FIRST ORDER DIFFERENTIAL EQUATION
» ABSTRACT This study deals with the reliability and availability characteristics of two different systems, the second system differs from the first sys...Continue Reading »Item Type & Format: Project Material  Ms Word  61 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

2. THE RELEVANCE OF THE USE OF METHOD OF UNDETERMINE COEFFICIENTS FOR SOLVING DIFFERENTIAL EQUATIONS
» CHAPTER ONE 1.0 INTRODUCTION 1.1 BACKGROUND OF STUDY The method of undetermined coefficient has been used as a tool for solving a particular non homog...Continue Reading »Item Type & Format: Project Material  Ms Word  33 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

3. THE COMPARISON OF GAUSSIAN ELIMINATION AND CHOLESKY DECOMPOSITION METHODS TO LINEAR SYSTEM OF EQUATIONS.
» CHAPTER ONE LINEAR SYSTEM OF EQUATIONS INTRODUCTION A wide variety of problems lead ultimately to the need to solve a linear system of equation linear...Continue Reading »Item Type & Format: Project Material  Ms Word  82 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

4. IMAGES OF MATHEMATICS STAKEHOLDERS IN TEACHING AND LEARNING MATHEMATICS AT SECONDARY SCHOOLS IN SOKOTO STATE
» ABSTRACT The study was conducted for images of mathematics stakeholders in teaching and learning mathematics at secondary schools. For the purpose of ...Continue Reading »Item Type & Format: Project Material  Ms Word  75 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

5. MATHEMATICAL MODEL OF CEREBROSPINAL MENINGITIS IN OBUASI MUNICIPALITY OF ASHANTI REGION, GHANA
» ABSTRACT Meningococcal disease is a serious health threat in the human body which begins rapidly with a relative high case fatality rate particularly ...Continue Reading »Item Type & Format: Project Material  Ms Word  52 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

6. NUMERICAL METHODS FOR SOLVING PARTIAL DIFFERENTIAL EQUATION
» CHAPTER ONE 1.0 INTRODUCTION 1.1 BACKGROUND OF STUDY Partial differential equations (PDEs) provide a quantitative description for many central models ...Continue Reading »Item Type & Format: Project Material  Ms Word  56 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

7. EFFECT OF INFORMATION AND COMMUNICATION TECHNOLOGY (ICT) ON PUPILS’ ACADEMIC ACHIEVEMENT IN MATHEMATICS IN EKET LOCAL GOVERNMENT AREA OF AKWA IBOM S...
» ABSTRACT This study examined Effect of Information and Communication Technology (ICT) on Pupils’ Academic Achievement in Mathematics in Eket Loc...Continue Reading »Item Type & Format: Project Material  Ms Word  52 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

8. ASSESSING THE EFFECT OF GOOD KNOWLEDGE OF MATHEMATICS ON STUDENTS PERFORMANCE IN PHYSICS
» CHAPTER ONE INTRODUCTION 1.1 Background of the Study Science has been regarded as the bed rock on which modern day technological breakthrough is built...Continue Reading »Item Type & Format: Project Material  Ms Word  52 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

9. MAGNETOHYDRODYNAMIC UNSTEADY FREE CONVECTION FLOW PAST VERTICAL POROUS PLATES WITH SUCTION AND OSCILLATING BOUNDARIES
» ABSTRACT In this dissertation, the problems of Magnetohydrodynamic unsteady free convection flow past vertical porous plates with suction and oscillat...Continue Reading »Item Type & Format: Project Material  Ms Word  46 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT

10. MATRIX AND ITS APPLICATIONS
» CHAPTER ONE INTRODUCTION AND LITERATURE REVIEW 1.1 BACKGROUND OF THE STUDY The introduction and development of the notion of a matrix and the subject ...Continue Reading »Item Type & Format: Project Material  Ms Word  49 pages  Instant Download  Chapter 15  MATHEMATICS DEPARTMENT